Experiments validate models predicting failure modes in miniaturized lightweight structures

43 views Leave a comment

Lawrence Livermore National Laboratory (LLNL) researchers have adapted theoretical models to predict the failure behavior of miniaturized 3D lattice structures and have used advanced characterization techniques to demonstrate that these failures exist.

In situ compression results for a 10 percent octet structure show the force versus displacement plot for the same octet sample. At left, the 3D tomography surface under no load and at right, after the onset of an elastic deformation.

Specifically, experiments showed a transition in failure modes for stretch-dominated lattice structures at low relative densities. Understanding the dominant failure mode is critical to the deployment of lightweight micro-trusses as it influences the energy absorption capacity of the structure.

Lightweight lattice structures, like trusses, have been used for centuries — think of trestle bridges and the Eiffel Tower as common examples — due to their low density and high specific strength and stiffness. With additive manufacturing (3D printing), these types of structures can be miniaturized to considerably smaller length scales. However, scientists were not sure if models, used to predict the failure behavior of large-scale ligh-weight structures, would hold up at the smaller-length scales.

LLNL researchers Mark Messner (now at Argonne National Laboratory) and Holly Carlton have published these findings in the Journal of Mechanics and Physics of Solids (link is external) and Acta Materialia (link is external), respectively. Messner used a newly developed equivalent continuum model to predict failure behavior in truss structures. This method, applied to standard cell topologies, predicts a tradeoff between a more graceful yield-dominated and a catastrophic buckling-dominated failure mode at a critical relative density. However, the critical relative density predicted in his theoretical model depends on several modeling assumptions that are strongly influenced by the manufacturing process.

At this point, Carlton conducted quasi-static compression tests coupled with in situ tomography at Lawrence Berkeley National Laboratory’s Advanced Light Source (link is external). These experiments on miniaturized 3D-printed structures captured real-time deformation in unit cell lattice structures, specifically showing a transition in failure mode from catastrophic buckling to yielding at a low relative density (between 10-20 percent of bulk density), which validates Messner’s model predictions.

These are the first studies where theoretical models were used to predict failure in miniaturized lattice structures and then tested experimentally to evaluate whether these predictions hold up. These findings have implications for how scientists and engineers design and fabricate architected structures for future applications.

Other LLNL authors on the study are Jonathan Lind, Nickolai Volkoff-Shoemaker, Nathan Barton and Mukul Kumar.

Source: LLNL

Comment this news or article